Instructions
Step 1: Working on the Non-Stick Craft Sheet apply a thin layer of clay over the inside of the ICE Resin Heart Milan Bezel.
Step 2: Roll a 1/8” coil.
Step 3: Add coils to the bezel cutting off the edges with a toothpick.
Step 4: Using a toothpick pull out the veins of the leaves. The center of the leaf is a little wider than the tip of the leaf.
Step 5 : Make a ball of QuickCure Clay about ¼” and smash it down with your fingers to make an uneven edged pancake. Apply it to the ICE Resin Bezel. This is the beginning of the flower.
Step 6: Make another slightly smaller ball and repeat the last step.
Step 7: Make a very small ball and apply it to the center of the flower. Using a toothpick, make a hole in the center of the ball of clay.
Step 8: Make a series of graduated QuickCure Clay balls.
Step 9: Apply the balls of clay to the bezel. Using a toothpick poke holes in the clay balls.
Step 10: Using a toothpick, poke holes in all the smooth background areas of the QuickCure Clay for interest. You can add a ball at the bottom of the heart and put a large hole in it and a small tiny ball in the center to make another flower. You can add as many flowers as you like. This is just a sample of techniques you can use. Don’t be afraid to come up with your own design.
Step 11: To cure the pendant, use a Ranger Heat It Craft Tool and rotate the heat tool over the piece. Hold the heat tool to one side and it will use frontal polymerization to cure the clay. The heat with move in a line across the pendant to cure the clay. Test the piece with a toothpick to see if it totally cured. It only takes a couple of minutes.
Step 12: The pendant can be left as is for a natural look or colorized with a variety of inks and other colorants.
Hello, I’m a mixed media artist living here in northern NJ. I’ve been working with Quick Cure Clay for several months since its release. I’m an active member and admin for the Quick Cure Clay Group on Facebook. I’d like to discuss the possibility of working with Ranger as an outside qcc workshop instructor, visiting local Art stores in the Tri-State area that are selling QCC. I could visit these stores as an ambassador for the product. I can also travel outside the Tri-State area for trade shows and demonstrations. You can see my work with qcc on the Facebook group page. Just type in my name to see all my posts. My speciality is working with silicone molds to create jewelry and mixed media collage. I can be reached at 551-486-6068 or at mtarricone70@gmail.com. I thank you for your consideration. John Pojman, creator of qcc has suggested I contact you.